Emerson Micro Motion 1500 Configuration And Use Manual page 61

Table 5-2: Status alerts and Status Alert Severity
Alert code Status message
A031 Low Power
A032 Meter Verification in Pro-
gress: Outputs to Fault
A033 Insufficient Right/Left Pick-
off Signal
A034 Meter Verification Failed
Meter Verification Aborted Fault
A035
A100 mA Output 1 Saturated
A101 mA Output 1 Fixed
A102 Drive Overrange
A104 Calibration in Progress
A105 Slug Flow
A106 Burst Mode Enabled
A107 Power Reset Occurred
A108 Basic Event 1 On
A109 Basic Event 2 On
A110 Frequency Output Satura-
ted
A111 Frequency Output Fixed
A112 Upgrade Transmitter Soft-
ware
A113 mA Output 2 Saturated
A114 mA Output 2 Fixed
A115 No External Input or Polled
Data
Configuration and Use Manual
(continued)
Default severity Notes
Fault
Applies only to flowmeters with the
enhanced core processor.
Varies Applies only to transmitters with
Smart Meter Verification.
If outputs are set to Last Measured
Value, severity is Info. If outputs are
set to Fault, severity is Fault.
Fault
Applies only to flowmeters with the
enhanced core processor.
Fault
Applies only to transmitters with
Smart Meter Verification.
Applies only to transmitters with
Smart Meter Verification.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational Normal transmitter behavior; oc-
curs after every power cycle.
Informational
Applies only to basic events.
Informational
Applies only to basic events.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Applies only to systems with trans-
mitter software earlier than v5.0.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Configure device options and preferences
Configurable?
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
55