3.4 Opening the console
You can perform the following tasks in the console:
• Monitor system performance
• Specify settings for certain module parameters
• Run diagnostic tests
• View an interactive diagram of the module components
3.4.1 Opening the console from Empower software
To open the console:
1.
From the Empower navigation bar, select Run Samples and then Control
Panel.
Result:
2.
In the sample manager control panel, click Display console
Alternative:
Console from the menu that appears.
3.4.2 Opening the console from MassLynx software
To open the console:
1.
From the MassLynx window, click Inlet Method.
2.
Click the Additional Status tab.
Result:
3.
In the sample manager control panel, click Display console
Alternative:
Console from the menu that appears.
3.5 Priming the system
Requirement:
after changing the mobile phase, after changing the sample needle, and after the
system has been idle for four hours or more.
A control panel for each device in the system appears.
Right-click the control panel for any module, and select Launch
A control panel for each device in the system appears.
Right-click the control panel for any module, and select Launch
You must prime the system after starting up the system, as well as
June 12, 2015, 715004747 Rev. A
Page 44
.
.