Phone Ui Related Settings - Avaya Vantage K175 Installing And Administering

Phone UI related settings

Common operations
Parameter
HEADSETBIDIR
CLICKS
September 2018
Type Default Is set to
value default
on reset
Numeric 0 Yes
Numeric 1 No
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
Specifies whether bidirectional signaling is
supported on the headset interface. Bidirectional
signalling allows you to forward off-hook events and
incoming call alerts from Avaya Vantage
headset when a headset base station is connected
to the headset connector.
Assign one of the following values:
• 0: Disabled.
• 1: Switch hook and alert signaling are both
enabled.
• 2: Only switch hook signaling is enabled.
Important:
This parameter must only be used when using
a wireless headset if the base station is
connected to the headset connector of the
device. In other cases, such as when using a
wired headset, the value must be set to 0.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
• The Settings > Audio settings > Headset
signalling menu on the device.
This parameter is supported in all modes.
This parameter can be stored on the PPM or
backup server.
Specifies whether touch sounds are enabled.
• 0: Touch sounds are disabled.
• 1: Touch sounds are enabled.
This parameter is supported in all modes.
For provisioning, use the Settings > Sound &
notification > Other sounds > Touch sounds
menu on the device.
™
Phone UI related settings
™
to a
Table continues...
109