Avaya Vantage K175 Installing And Administering page 52

Security configuration
Parameter
L2QVLAN
VLANTEST
VLANSEP
PHY2TAGS
PHY2VLAN
For a full VLAN separation between the device and computer packets, the VLAN configuration
must meet the following conditions:
• VLANSEP is 1
• L2Q is 0 or 1
• L2QVLAN is not equal to 0
• PHY2VLAN is not equal to 0
• L2QVLAN is not equal to PHY2VLAN
• VLANTEST is 0 or timer is less than VLANTEST
The device tries to obtain an IP address from the DHCP server on the voice VLAN. If the device
gets an IP address, the device sends all the tagged packets on the voice VLAN. Set the
PHY2VLAN parameter to the data VLAN so that untagged packets from the computer are
assigned to the data VLAN. Tagged packets from VLAN computers other than the data VLAN are
blocked. PHY2VLAN is important for a full VLAN separation between the computer and the device
VLANs.
September 2018
Set to Notes
unreachable, the device sends untagged packets. On Avaya
™
Vantage , the behavior is same for both values.
• Untag (2): The device sends untagged packets.
Non- Specifies the 802.1Q VLAN identifier. This parameter must not
zero have the same value as that of PHY2VLAN.
value
0 to 999 Specifies the number of seconds to wait for a DHCPOFFER
message reception on a non-zero VLAN. The default value is 60
seconds.
1 Enables the VLAN separation.
0 or 1 Specifies whether tags are stripped from frames forwarded to the
secondary Ethernet interface.
• 0: VLAN tags are removed from frames forwarded to the
secondary Ethernet interface.
• 1: VLAN tags are not removed from frames forwarded to the
secondary Ethernet interface.
Non- Specifies the value of the 802.1Q VLAN identifier for tagged
zero frames through the secondary Ethernet interface. This parameter
value must not have the same value as that of L2QVLAN.
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
™
52