Comtech EF Data DMD1050TS Installation And Operation Manual page 166

7.7.3.2 Interface | RX Setup Page
Interface | RX Setup Page
Circuit ID
Terrestrial
Streaming
Terrestrial Interface
Esc Ch. 1 Gain
Esc Ch. 2 Gain
BUFFER CLOCK CONTROL Section
Buffer Size (msec)
Buffer Clock Polarity
Number of Buffer
Sources
Active Buffer Clock
Web Browser
Figure 7-25. Interface | RX Setup Page Example
BYTE OUTPUT
•
PACKET OUTPUT
•
ETHERNET
•
MIL 188 114A
•
-20 to +10 dB
•
-20 to +10 dB
•
0 – 64 msecs
•
NORMAL
•
INVERTED
•
1 – 5
•
RXSAT
•
EXTBNC
•
SCTE
•
SCT
•
EXT IDI
•
7–44
DMD1050TS Satellite Modem Board
Use to enter a Rx Circuit Identifier. Circuits can have an
identifier of up to 11 alphanumeric characters, such as
DLINK1.
ASI only. BYTE OUTPUT: Continuous PACKET OUTPUT:
Burst.
Use to select the Receive type.
Use to select ESC Voice Channel Gain. Only displayed
when IDR NETWORK and VOICE Channel are selected.
Use to select ESC Voice Channel Gain. Only displayed
when IDR NETWORK and VOICE Channel are selected.
Use to set the Doppler Buffer Size in msec.
Use to select the Buffer Clock Polarity for the Tx Terrestrial
Clock, relative to the Tx Data. If the G.703 Interface is
active, the Buffer Clock Polarity cannot be changed.
Use to select up to 5 clock sources.
Read only; shows the active buffer clock source.
Revision 1
MN-DMD1050TS