Remote Monitor And Control Via Snmp - Comtech EF Data DMD1050TS Installation And Operation Manual

F.7

Remote Monitor and Control via SNMP

SNMP is the most widely used protocol for network management available today. It provides a
secure, open network standard, whereby you can use a PC with an MIB Browser to monitor and
control almost any Cisco router, gateway or Radyne modem.
Because the Enhanced Ethernet Interface offers a multi-port Ethernet interface and daisy chain
capability, you can control every modem easily from one central location. This is true for modems
in complex point to multi-point systems, as well. This all occurs without extensive network setup
or additional equipment at every remote site.
Figure F-6 shows complete Monitor and Control of all Radyne equipment from a centrally located
PC at the Hub.
Hub
Router
LAN
Switch
Appendix F
DMD 50
M&C
Daisy Chain
DMD 20
M&C
Daisy Chain
DMD20
M&C
Figure F-6. Remote Monitor and Control
F–6
DMD1050TS Satellite Modem Board
Router
DMD50
M&C
Router
DMD50
M&C
Router
DMD50
M&C
MN-DMD1050TS
Revision 1
Remote
LAN
Remote
LAN
Remote
LAN