Modem Ip Address Submenu; Server Ip Address Submenu; Router Ip Address Submenu; Modem Ethernet Address Submenu - Comtech EF Data DMD1050TS Installation And Operation Manual

C.2.5 Modem IP Address Submenu
This allows you to enter the Modem's individual network IP Address. Each device on the network
must have a unique address. Contact the IP Administrator for the correct address setting.
Example Modem IP Address: 172.018.100.215
C.2.6 Server IP Address Submenu
This allows you to set up the Network Server IP Address. This address is for the Host that
optionally boots the DMD20 on power-up, and is the SNMP Trap Server. This IP Address must be
consistent with the Modem IP Address. Broadcast and loop back addresses are not allowed.
Example Server IP Address: 172.018.004.250
C.2.7 Router IP Address Submenu
This allows you to set up the Network Router IP Address. If a router exists on the local network,
and it is to be used, this address must be consistent with the IP Address Mask and the subnet of
the modem. If no router is present, then the address must be set to a foreign address. Broadcast
and loop back addresses are not allowed.
Example for router not used: Router IP Address: 010.000.001.001
C.2.8 Modem Ethernet Address Submenu
This shows the Modem (Unit) Ethernet Address. The Modem Ethernet Address is configured at
the factory. It is a unique, Radyne equipment identifier address.
Example: 0010650903EB
C.2.9 Ethernet Rate Submenu
This shows the operating Ethernet port data rate. If multiple rates are available, then you can
specify the Ethernet port data rate (10BaseT).
Example Ethernet port Data Rate: 10 MBPS/HD
Appendix C
DMD1050TS Satellite Modem Board
C–3
Revision 1
MN-DMD1050TS