Chapter 4. Rear Panel Interface; Dmd1050Ts Connections - Comtech EF Data DMD1050TS Installation And Operation Manual

Chapter 4. Rear Panel Interface

This section discusses the electrical interfaces on the rear panel. All locations are as seen from
the rear of the unit, unless specified otherwise.
4.1

DMD1050TS Connections

All DMD1050TS connections are made to labeled connectors located on the Modem Board.
See Figure 4-1, Figure 4-2, Figure 4-3, and Figure 4-4.
You must use the correct connector to make any connection to the DMD1050TS. See Appendix E
for information about the connectors that are used with the DMD1050TS.
The DMD1050TS consists of these assemblies:
•
RF Board (PL-0021834)
•
Baseband Modem Board (PL-0022534)
•
FIPs Security Module (PL-0000192)
Rear Panel Interface
DMD1050TS Satellite Modem Board
4–1
Revision 1
MN-DMD1050TS