Comtech EF Data DMD1050TS Installation And Operation Manual page 133

IP Administration | Configure Applications
SNMP Setup
SNMP Version
Trap Version
Authorization
Read Community
Read/Write
Community
FTP Setup
User ID
Password
Click Save (or Cancel).
Web Browser
V1 & V2 (default)
•
V3
•
V1 (default)
•
V2
•
TRAPS ON (default)
•
TRAPS OFF
•
16 characters of name
Default = public
16 characters of name
Default = public
7–11
DMD1050TS Satellite Modem Board
This selection controls the Simple Network Management
Protocol (SNMP) Version that will be used in messaging
between the equipment and its host.
When V1 & V2 is used, RD COMMUNITY and RDWR
COMMUNITY are used to determine the authorization of an
incoming message.
When V3 is used, three contexts are supported: public, mib2,
and dev. Context, Authentication and Privacy are a portion
of each SNMPV3 message.
The public context will only allow the user to see the sysoid
of the unit. This is the most restricted access possible and
only allows the unit to be identified by a host SNMP Station.
The mib2 context allows a user with appropriate
authentication to access the mib2 Object Identifiers (OIDs)
and the SNMP OIDs. These are of interest primarily to
network operators not controlling the satellite link.
The dev context allows a user with appropriate
authentication to access the device control portion of the
MIB. These OIDs are used to control the devices satellite
link and operation.
This controls the type of message format used when a
message trap is generated by the equipment and bound for a
SNMP Host. Messages will only be sent if the unit has been
authorized to do so.
This controls the type of message format used when a
message trap is generated by the equipment and bound for a
SNMP host. Messages will only be sent if the unit has been
authorized to do so.
This menu is only displayed when SNMP VERSION is set to
V1 & V2. This is the community that a host must be acting
within when an OID variable is requested by a V1/V2 SNMP
message.
This menu is only displayed when SNMP VERSION is set to
V1 & V2. This is the community that a host must be acting
within when an OID variable is being changed by a V1/V2
SNMP message.
Enter the user identification for access to an FTP session.
Enter the password for access to an FTP session.
Revision 1
MN-DMD1050TS