Configure Informational Parameters; Configure Sensor Serial Number - Emerson Micro Motion 2700 Configuration And Use Manual

Table 5-2: Status alerts and Status Alert Severity
Alert code Status message
A121 Extrapolation Alarm (Con-
centration)
A131 Meter Verification in Pro-
gress: Outputs to Last
Measured Value
A132 Sensor Simulation Active
A141 DDC trigger(s) have com-
pleted
5.6

Configure informational parameters

The informational parameters can be used to identify or describe your meter. They are not
used in process measurement and they are not required.
5.6.1

Configure Sensor Serial Number

Display
ProLink III
Field Communicator Configure > Manual Setup > Info Parameters > Sensor Information > Sensor Serial Num-
Overview
Sensor Serial Number lets you store the serial number of the sensor component of your
flowmeter in transmitter memory. This parameter is not used in processing and is not
required.
Procedure
1.
2.
Configuration and Use Manual
Default severity Notes
Informational
Informational
Informational
Informational
Not available
Device Tools > Configuration > Informational Parameters > Sensor
ber
Obtain the sensor serial number from your sensor tag.
Enter the serial number in the Sensor Serial Number field.
Configure device options and preferences
(continued)
Applies only to transmitters with
the concentration measurement
application.
Applies only to transmitters with
Smart Meter Verification.
Applies only to flowmeters with the
enhanced core processor.
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Applies only to flowmeters with the
enhanced core processor.
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Configurable?
Yes
Yes
To Informational or
Ignore only
Yes
83