Configure Ma Output Fault Action And Ma Output Fault Level - Emerson Micro Motion 2700 Configuration And Use Manual

Integrate the meter with the control system
•
Result: A change in the mass flow rate will be reflected in the mA Output over a time
period that is greater than 3 seconds. The exact time period is calculated by the
transmitter according to internal algorithms which are not configurable.
6.2.5 Configure mA Output Fault Action and mA Output Fault
Level
Display
ProLink III
Field Communicator
Overview
mA Output Fault Action controls the behavior of the mA Output if the transmitter
encounters an internal fault condition.
Note
For some faults only: If Fault Timeout is set to a non-zero value, the transmitter will not implement
the fault action until the timeout has elapsed.
Procedure
1.
2.
Postrequisites
CAUTION!
If you set mA Output Fault Action or Frequency Output Fault Action to None, be sure to set
Digital Communications Fault Action to None. If you do not, the output will not report actual
process data, and this may result in measurement errors or unintended consequences for your
process.
96
mA Output Damping = 2 seconds
Not available
Device Tools > Configuration > Fault Processing
• Configure > Manual Setup > Inputs/Outputs > mA Output 1 > MA01 Fault Settings
• Configure > Manual Setup > Inputs/Outputs > mA Output 2 > MA02 Fault Settings
Set mA Output Fault Action to the desired value.
The default setting is Downscale.
Restriction
If Digital Communications Fault Action is set to NAN (not a number), you cannot set mA
Output Fault Action or Frequency Output Fault Action to None. If you try to do this, the
transmitter will not accept the configuration.
If you set mA Output Fault Action to Upscale or Downscale, set mA Output Fault Level
as desired.
Micro Motion Model 2700 Transmitters with Intrinsically Safe Outputs