Welch Allyn Acuity Directions For Use Manual page 48

44 Chapter 4 Adjust monitoring settings and patient information
Table 2. Typical monitoring functions at the Virtual Monitor
Response time: SpO
Task
(Propaq Encore and CS
monitors) Set SpO
response time.
(Propaq Encore and CS
monitors) Set CO
response time.
Waveforms and pacer display
Adjust sweep speed of
all waveforms except
CO and RESP.
2
Optimize all waveform
scales (except CO
Turn on or turn off the
pacer display.
and CO
2 2
Clicks at Virtual Monitor
1. SpO2 or SpO2/CO2
2. SpO2
2
3. MORE
4. RESPONSE
1. SpO2/CO2
2. CO2
2
3. MORE
4. RESPONSE
1. MAIN MENU
2. MORE
3. MORE
4. NEXT
5. CHANGE
1. MAIN MENU
). 2. MORE
2
3. STATSCALE
No Arrhythmia Analysis
option:
1. ECG or ECG/RESP
2. MORE, (MORE), (MORE)
3. NEXT
4. CHANGE
Arrhythmia Analysis option:
1. Setup
2. Arrhythmia Alarms
3. Pacer Display
Also set Analyze Pacer for
arrhythmia monitoring. For
instructions, please see
page 62.
Welch Allyn Acuity Central Monitoring System
Notes
Can be changed also at the patient monitor.
Can be changed also at the patient monitor.
Waveform sweep speed changes in the Virtual Monitor and
Waveform Window.
You can adjust RESP sweep speed separately in this window,
and CO sweep speed changes with it.
2
Waveforms are adjusted for best display in the Virtual
Monitor and Waveform Window.
The pacer display is shown as a dashed line in the waveform
areas of the Virtual Monitor, Waveform Window and
Waveforms Review window.
WARNING Keep all pacemaker patients under close
observation. Rate meters might continue to count the
pacemaker rate during occurrences of cardiac arrest or
some arrhythmias. Do not rely solely upon rate meter
alarms.
WARNING Always turn on Analyze Pacers for paced
patients, and always turn off Analyze Pacers for non-
paced patients. The Acuity System analyzes
arrhythmias based on whether the Analyze Pacers
setting is on or off. The Analyze Pacers setting is Off
.
by default