Table of Contents
Advertisement
166
Chapter 10 Troubleshooting and maintenance
Identify or change a Micropaq monitor network name
To identify a Micropaq monitor network name
1. Press
The System Information menu appears.
2. Press
The Network Status screen appears.
3. Locate the Network Name in the list.
4. Press
To change a Micropaq monitor network name
1. Press
The Service menu appears.
2. In this sequence and not too rapidly, press and hold these keys:
An ARE YOU SURE? prompt appears.
3. Press
A Network Name menu appears.
4. Press
5. Carefully confirm that the highlighted name matches the appropriate Acuity System
network name.
6. Press
The Micropaq monitor turns off and on again, and then it attempts to connect to the
Acuity System network.
to highlight SYSTEM INFORMATION, and then press
to highlight NETWORK STATUS, and then press
to exit.
repeatedly until SERVICE MENU is highlighted, and then press
,
and
.
to highlight YES, and then press
or
to highlight the desired network name.
.
Welch Allyn Acuity Central Monitoring System
.
.
.
.
Advertisement
Table of Contents
Troubleshooting
