Welch Allyn Acuity Directions For Use Manual page 171

Directions for use
Identify or change a Propaq LT monitor network name
To identify a Propaq LT monitor network name and prepare to change it (if desired)
1. Highlight SpO2, and then press
2. Highlight Setup, and then press
The Setup menu appears.
3. Highlight Service, and then press
The Service menu appears.
4. Highlight Radio, and then press
The Radio menu appears, and Show Info is highlighted
5. Take one of these steps:
• If you want to change the network name: Continue below to "To proceed to change a
Propaq LT monitor network name".
• If you do not want to change the network name:
a. Press
b. Highlight Exit, and then press
To proceed to change a Propaq LT monitor network name
1. Highlight NetName and press
2. Highlight the new network name.
3. Carefully confirm that the highlighted name matches the appropriate Acuity System
network name.
4. Simultaneously press
The Propaq LT monitor turns off and on again, and then it attempts to connect to the
Acuity System network.
.
The current network name is shown.
You have completed the network name identification process.
and
Chapter 10 Troubleshooting and maintenance
.
.
.
.
.
.
, and hold for one second.
167