Welch Allyn Acuity Directions For Use Manual page 193

Directions for use
Virtual Monitor and Waveform Window
Table 32. Virtual Monitor
Features
Virtual Monitor auto open
Patient mode
(listed in patient monitor
Setup status window)
Display settings
Lead selections
Number of waveforms
displayed simultaneously
Display priority of
waveforms
Number of vital sign
numerics displayed
simultaneously
Customizable default
Micropaq monitor: adult
Micropaq and Propaq LT monitors:
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
RESP LEAD is Lead III
3-wire cable:
ECG1 LEAD is Lead II
Propaq CS and Propaq Encore monitors:
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
3-wire cable:
ECG1 LEAD is Lead II
Welch Allyn 1500 Patient Monitor:
10-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
3-wire cable:
ECG1 LEAD is Lead II
Chapter 11 Specifications
Factory default
In map view and full screen review view:
• Upon patient's monitor connection to Acuity
System if empty window
• Upon alarm if open space is available OR
replaces a non-alarming Virtual Monitor
Propaq LT, CS and Encore monitors: Adult,
pediatric or neonate mode, depending upon
setting at patient monitor
Acuity System utilizes monitor factory default
settings. For further information, see the monitor
directions for use.
Up to three
All waveforms on (ECG always displayed if
monitored):
1. ECG 1 5. P2 9. RESP
2. ECG 2 6. P3 10. SpO
3. ECG 3 7. P4 11. NIBP
4. P1 8. CO
2
Eight (if six or more are monitored at once,
Temperature and NIBP values alternate in the
same space)
If CO is active and turned on at the patient
2
monitor, BR numerics are shown; second choice
is RR numerics, when impedance pneumography
is active
189
2