Broadcasting By Pressing The [Ptt] Key - Kenwood WD-K10 Series User Manual

3 MAKING A CALL
3.8 Broadcasting

Broadcasting by Pressing the [PTT] Key

By setting "Function Link with" to "Broadcast" and "Function Link Start" to "Enable Link with" in "Talk Setting", you can activate
the Broadcast function and start the broadcast by a single [PTT] key operation.
1
Press the [PTT] key on the clip microphone or transceiver.
The Broadcast function will activate and a mode change tone will emit. Start the broadcast after the mode change
tone is emitted.
Note
If "Function Link Start" is set to "Disable Link with", the operation is the same as
0
Key on page 61". Assign the Broadcast function to any function key to activate the Broadcast function.
2
While pressing the
The broadcast continues while the [PTT] key is pressed.
3
To end the broadcast, release the
with]. This will also deactivate the Broadcast function.
A mode change tone will emit and users will return to the "Group Call Mode" of their own groups.
Precautions
0
The operation is the same as "Broadcasting by Pressing the [Broadcast] Key" if "Function Link End" is set to
[Disable Link with].
Assign the Broadcast function to any function key to end the broadcast.
0
This activation method starts the broadcast when the [PTT] key is pressed so it is not suitable if you do not intent
to make a group intercom call.
Note
The broadcast will be canceled before the broadcast ends in the following cases.
0
When the time configured in Broadcast Timer has lapsed.
0
When the power of the transceiver that has started Broadcast is turned off, or when it is out of range.
0
When All Call has started.
0
[PTT] key, speak into the clip microphone.
[PTT] key if "Function Link End" in "Talk Setting" is set to
"Broadcasting by Pressing the [Broadcast]
[Enable Link
Contents
62