Changing Groups - Kenwood WD-K10 Series User Manual

3 MAKING A CALL

3.3 Changing Groups

3.3 Changing Groups
This function allows you to call a group that has been switched.
Precautions
0 The group that has been pre-configured in the system will be switched. For details on group settings, please consult the
authorized dealer or installer.
0 The [Group Select] key is not assigned by default. Assign the function to any function keys.
To configure the setting, consult the authorized dealer or installer.
1
Press the [Group Select]
Every time the [Group Select] key is pressed, the 4 groups will be switched in the order of A → B → C → D → A.
When a group is switched, the corresponding Group LED will light up for a few seconds and then blink. The name
of the switched group will be announced.
2
Speak into the microphone while pressing the
Note
When the power is turned off after changing the group, the group to connect to when the power is turned on
0
again varies according to the setting of the transceiver.
If "Power On Group" is set to "Resume": The group that the unit belonged to before turning off the power is
connected.
If a group is specified for "Power On Group": The specified group is connected regardless of the group that the
unit belonged to before turning off the power.
To configure group settings, consult the authorized dealer or installer.
0
The voice announcement may not be played depending on the transceiver settings. (
0
key.
Group LED
[PTT]
Group Select
key on the clip microphone or transceiver.
Contents
on page 47)
51