Interface Cable Wd-Rc50 - Kenwood WD-K10 Series User Manual

1 INTRODUCTION
1.8 Part Names and Functions (Device Connection Method)

Interface Cable WD-RC50

The transceiver connection cable WD-RC50 is a conversion cable for communication between the DECT intercom system
WD-K10 series and external wireless system (KENWOOD brand). (For 2-pin connector)
It is used to connect to the Portable base WD-K10PBS.
PMR Link jack
A
Connect to the 2-pin connector of the two-way radios of the KENWOOD in an external wireless system.
Cap
B
After connecting to the transceiver, turn the cap and secure.
Transceiver connection plug
C
For connecting to an appropriate transceiver.
Precautions
0
Insert firmly into the terminal so that the plug does not come off, and tighten the cap. If the cap is not fully tightened, poor
connection with the transceiver and noise may occur. Note that this is not water resistant.
0
When the plug is dirty, noise may occur during conversation. Wipe with a dry cloth regularly.
0
Be sure to connect or disconnect the plug only when the power is turned off.
A
B
C
Contents
24