Preparing The Device - Kenwood WD-K10 Series User Manual

2
PREPARATION
2.1

Preparing the Device

Replacing the Battery Pack
This transceiver comes with the battery pack already installed in it. To replace the battery pack, follow the steps below to
remove and install the battery pack.
1
Remove the screws (x6) on the rear of the transceiver and remove the rear cover.
2
Take out the battery pack and remove the battery connector.
When removing the connector, hold the base of the connector and pull it straight up slowly.
3
Connect the battery connector to the connector of the transceiver unit.
Connector
Connector
Contents
26