Download  Print this page

Turning On/Off The Power Of Wd K10Pbs / Wd-K10Tr - Kenwood WD-K10 Series User Manual

Dect intercom system
Hide thumbs

Advertisement

Table of Contents
2 PREPARATION
2.2 Turning On/Off the Device Power
Turning On/Off the Power of WD-K10PBS / WD-K10TR
Turning on the Power
1
Hold down the
[Power]
up and then light off.
0
Base Station Mode
When the unit is linked to the system, the Status LED blinks in orange. Group LEDs of the connected group light up for a few
seconds and then blink. Voice announcement for the connected group is being played and the unit enters Group Call Mode.
0
Transceiver Mode
When the unit is linked to the system, the Status LED blinks in green. Group LEDs of the connected group light up for a few
seconds and then blink. Voice announcement for the connected group is being played and the unit enters Group Call Mode.
When the unit is unable to link to the system, the Status LED lights up in red. Move to a location where linking is possible.
Turning off the Power
1
Hold down the
[Power]
Check that the LED lights off and is not blinking.
key. Release after the Status LED (red), Group LEDs, and Battery Charge LED light
Group LED
Status LED
Battery Charge LED
key until the Status LED lights off.
[Power] key
[Power] key
Contents
33

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood WD-K10 Series

  Related Content for Kenwood WD-K10 Series

This manual is also suitable for:

Wd-k10pbsWd-k10bsWd-k10tr