Kenwood WD-K10 Series User Manual page 38

2 PREPARATION
2.3 Registering the Device
4
Start the sub unit in registration mode.
While pressing the [All Call] key of the sub unit, press and hold the [Registration] key until the Status LED lights up
in green and all the Group LEDs are blinking.
The sub unit enters into registration mode.
The registration begins automatically when both the base unit and sub unit are in registration mode.
When registration is successful:
The Status LED of the sub unit lights up in green and all the Group LEDs light up.
When registration has failed:
The Status LED of the sub unit lights up in green but all the Group LEDs do not light up. Restart the units in
registration mode and register again.
0
All sub units are registered to the same group (Group A) by default.
5
Restart the sub unit.
When registration of sub unit is successful, restart the sub unit.
After registration is complete, exit registration mode by pressing and holding the [Registration] key on WD-K10BS.
Note
If registration fails repeatedly, the maximum number of registrations may have been exceeded.
0
Group LED
Status LED
[All Call] key
[Power] key
Contents
37