Kenwood WD-K10 Series User Manual page 36

2 PREPARATION
2.3 Registering the Device
Registering Sub Unit to WD-K10PBS (Base Station Mode)
Note
For details on how to switch WD-K10PBS to Transceiver Mode, refer to
0
page 38.
1
Turn off the base unit and sub unit if they have been turned on.
Press and hold the [Power] key until the Status LED goes off to turn off the power.
2
Start the base unit in registration mode.
While pressing the [All Call] key of the base unit, press and hold the [Power] key until the Status LED lights up in
green and all the Group LEDs are blinking.
The sub unit enters into registration mode.
3
Start the sub unit in registration mode.
While pressing the [All Call] key of the sub unit, press and hold the [Power] key until the Status LED lights up in green
and all the Group LEDs are blinking.
The sub unit enters into registration mode.
The registration begins automatically when both the base unit and sub unit are in registration mode.
When registration is successful:
The Status LED of the sub unit lights up in green and all the Group LEDs light up.
When registration has failed:
The Status LED of the sub unit lights up in green but all the Group LEDs do not light up. Restart the units in
registration mode and register again.
0 All sub units are registered to the same group (Group A) by default.
Group LED
Status LED
Starting WD-K10PBS in Transceiver Mode on
[All Call] key
[Power] key
Contents
35