Download  Print this page

Charging The Battery Pack - Kenwood WD-K10 Series User Manual

Dect intercom system
Hide thumbs

Advertisement

Table of Contents
2 PREPARATION
2.1 Preparing the Device

Charging the Battery Pack

Be sure to charge the transceiver using the charger KSC-48CR before using.
1
Remove the bracket underneath the charger and insert the DC plug of the AC adapter into the DC IN jack
of the charger.
For details on installing and removing the bracket, refer to the instruction manual of the charger KSC-48CR.
2
Insert the cable of the AC adapter into the left or right groove depending on where the charger is set up.
3
Reinstall the bracket and insert the AC adapter into the AC outlet.
4
Place the transceiver with the battery pack installed onto the charger.
0
The battery charge LED lights up in red and charging begins.
0
The transceiver turns off automatically if it is placed on the charger while it is turned on. For safety purpose, turn
off the transceiver during charging.
0
Check that the metal terminals of the transceiver are in firm contact with the terminals on the charger.
0
The battery charge LED goes off when charging is complete. Take out the transceiver.
0
The estimated time required to complete the charging is as follows:
WD-K10PBS: Approx. 6 hours
WD-K10TR: Approx. 5 hours
Precautions
0
Be sure to use the specified charger WD-C100CR to charge WD-K10PBS and WD-K10TR.
In this illustration, the cable is inserted in the left groove.
Transceiver
(WD-K10PBS / WD-K10TR)
Charger
(KSC-48CR)
AC Adapter
(KSC-44SL)
Groove
To AC OUTLET
Contents
28

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood WD-K10 Series

This manual is also suitable for:

Wd-k10pbsWd-k10bsWd-k10tr