Performing Pmr Link - Kenwood WD-K10 Series User Manual

Dect intercom system
Table of Contents

Advertisement

3 MAKING A CALL

3.6 Performing PMR Link

3.6
Performing PMR Link
This system allows audio signals in group calls to be transmitted to groups of external wireless systems by using a transceiver
connection cable WD-RC100 to connect the Transceiver WD-K10TR and Portable base WD-K10PBS to specified two-way
radios.
Overview of PMR Link
0
The following models of two-way radios can be connected to external systems using PMR Link.
Target transceivers: KENWOOD two-way radios
Models using WD-RC100: NX-200G, NX-300G, NX-5200, NX-5300
Models using WD-RC50: NX-220, NX-320, TK-2000, TK-3000, TK-2302, TK-3302, TK-3401D, TK-3501
0
Contents of mixed calls within the sending area can be heard at terminals in the receiving area through two-way radios.
However, as this is an alternate communication, calls within the receiving area cannot be heard during transmission at
the sending area.
Simultaneous calls can be made within each area.
Control Microphone
EMC-13
Precautions
0
In order to perform PMR Link, it is necessary to connect the transceiver connection cable WD-RC100 (
change system setup. For details on the system setup, please consult the authorized dealer or installer.
0
As far as possible, use the transceiver and portable base at a distance away from external wireless systems. An error
due to radio wave interference may occur if they are too near.
0
If the Background Noise function is set to "ON" when connecting WD-K10PBS to a transceiver, turn the volume knob of
the transceiver to the 3 o'clock position. If the knob is not turned properly, the transceiver will remain in the mute status
and audio signals will not be output.
Two-Way Radio
NX-5200
Interface Cable
WD-RC100 or WD-RC50
AREA A
AREA B
on page
Contents
30) and
54

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd-k10pbsWd-k10bsWd-k10tr

Table of Contents