D-Link DGS-1510 Series Web Ui Reference Manual page 262

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
IP Precedence
ToS
DSCP
VID
CoS
Time Range
After selecting the ESP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
Fragments
from are Any, Host, and MAC. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's
MAC address here. When the MAC option is selected, the Wildcard
option will also be available. Enter the destination MAC address and
wildcard value in the spaces provided.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the VLAN ID that will be associated with this ACL rule here. This
value must be between 1 and 4094.
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Enter the name of the time range to associate with this ACL rule.
Figure 8-91 Extended Expert ACL (Add Rule) ESP window
Description
Select the Fragments option to include packet fragment filtering.
254