D-Link DGS-1510 Series Web Ui Reference Manual page 188

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Destination
IP Precedence
ToS
DSCP
Time Range
Action
After selecting the GRE option as the Protocol Type, the following section will appear.
Figure 8-11 ACL Configuration Wizard (Add Rule for IPv4 ACL) GRE window
The dynamic fields that can be configured are described below:
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the name of the time range to associate with this ACL rule.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
180