D-Link DGS-1510 Series Web Ui Reference Manual page 407

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Event description: The authorized user number on the whole device is below the
maximum user limit in a time interval.
Log Message: MAC-based Access Control recovers from stop learning state.
Event description: The authorized user number on an interface has reached the
maximum user limit.
Log Message: <interface-id> enters MAC-based Access Control stop learning
state.
Parameters description:
interface-id: The interface on which the host is authenticated
Event description: The authorized user number on a interface is below the
maximum user limit in a time interval.
Log Message: <interface-id> recovers from MAC-based Access Control stop
learning state.
Parameters description:
interface-id: The interface on which the host is authenticated
MSTP Debug Enhancement
Log Description
Event description: Used to record the event that Spanning Tree Protocol is
enabled.
Log Message: Spanning Tree Protocol is enabled
Event description: Used to record the event that Spanning Tree Protocol is
disabled
Log Message: Spanning Tree Protocol is disabled.
Event description: Used to record MSTP instance topology change event.
Log Message: Topology changed (Instance : < Instance-id >,<interface_id>,
MAC:<macaddr> )
Parameters description:
Instance-id: MST instance id. Instance 0 represents for default instance,
CIST.
interface_id: The port number which detect or reive topochange
information.
macaddr: The system of bridge mac address.
Event description: Used to record MSTP instance new root bridge selected.
Log Message: [CIST | CIST Regional | MSTI Regional] New Root bridge selected
([Instance: <Instance-id>] MAC: <macaddr> Priority :< priority>)
Parameters description:
Instance-id: MST instance id. Instance 0 represents for default instance,
CIST.
macaddr: The system of bridge mac address.
priority: The bridge priority value must be divisible by 4096
Event description: Used to record MSTP instance new root port selected.
Log Message: New root port selected (Instance:<Instance-id >, <interface_id >)
Parameters description:
Instance-id: MST instance id. Instance 0 represents for default instance,
CIST.
interface_id: The port number which detect or rereive topochange
399
Warning
Warning
Warning
Severity
Informational
Informational
Notice
Informational
Notice