D-Link DGS-1510 Series Web Ui Reference Manual page 197

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Time Range
Action
After selecting the Protocol ID option as the Protocol Type, the following section will appear.
Figure 8-18 ACL Configuration Wizard (Add Rule for IPv4 ACL) Protocol ID window
The dynamic fields that can be configured are described below:
Parameter
Protocol
Fragments
Source
Destination
between 0 and 63.
Enter the name of the time range to associate with this ACL rule.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Description
Enter the Protocol ID value in the space provided. This value must be
between 0 and 255.
Select the Fragments option to include packet fragment filtering.
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
189