D-Link DGS-1510 Series Web Ui Reference Manual page 219

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Parameter
Source
Destination
Source Port
Destination Port
IP Precedence
ToS
DSCP
Time Range
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the source port value here. Options to choose from
are =, >, <, ≠, and Range. When selecting the = option, the specific
selected port number will be used. When selecting the > option, all
ports greater than the selected port, will be used. When selecting the <
option, all ports smaller than the selected port, will be used. When
selecting the ≠ option, all ports, excluding the selected port, will be
used. When selecting the Range option, the start port number and end
port number selected, of the range, will be used. Alternatively, the port
number(s) can manually be entered in the space(s) provided, if the
port number(s) is/are not available in the drop-down list.
Select and enter the destination port value here. Options to choose
from are =, >, <, ≠, and Range. When selecting the = option, the
specific selected port number will be used. When selecting the >
option, all ports greater than the selected port, will be used. When
selecting the < option, all ports smaller than the selected port, will be
used. When selecting the ≠ option, all ports, excluding the selected
port, will be used. When selecting the Range option, the start port
number and end port number selected, of the range, will be used.
Alternatively, the port number(s) can manually be entered in the
space(s) provided, if the port number(s) is/are not available in the
drop-down list.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the name of the time range to associate with this ACL rule.
211