D-Link DGS-1510 Series Web Ui Reference Manual page 200

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
After selecting the TCP option as the Protocol Type, the following section will appear.
Figure 8-21 ACL Configuration Wizard (Add Rule for IPv6 ACL) TCP window
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Source Port
UDP, ICMP, Protocol ID, ESP, PCP, SCTP, and None.
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IPv6. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IPv6 address here.
When the IPv6 option is selected, the Prefix Length option will also be
available. Enter the source IPv6 address and prefix length value in the
spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, and IPv6. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's
IPv6 address here. When the IPv6 option is selected, the Prefix
Length option will also be available. Enter the destination IPv6
address and prefix length value in the spaces provided.
Select and enter the source port value here. Options to choose from
are =, >, <, ≠, and Range. When selecting the = option, the specific
selected port number will be used. When selecting the > option, all
ports greater than the selected port, will be used. When selecting the <
option, all ports smaller than the selected port, will be used. When
192