6.4 Adjust Parameters - JLG T500J Service And Maintenance Manual

SECTION 6 - JLG CONTROL SYSTEM
Use the UP or DOWN
ond digit of the password which is 33271.
Continue using the arrow keys until all the remaining digits of
the password is shown.
Once the correct password is displayed, press ENTER
The access level should display the following, if the password
was entered correctly:
MENU:
ACCESS LEVEL 1
ESC
MENU: 
ACCESS LEVEL 1
Repeat the above steps if the correct access level is not dis-
played or you can not adjust the personality settings.
6-4
arrow key to enter the sec-
ENTER
MAE19060

6.4 ADJUST PARAMETERS

Once you have gained access to level 1, and a personality item
is selected, press the UP
adjust its value, for example:
.
PERSONALITIES:
LIFT ACCEL 1.0
PERSONALITIES:
LIFT ACCEL 1.0s
There will be a minimum and maximum for the value to
ensure efficient operation. The Value will not increase if the
UP arrow is pressed when at the maximum value nor
will the value decrease if the DOWN
and the value is at the minimum value for any particular per-
sonality. If the value does not change when pressing the up
and down arrows, check the access level to ensure you are at
access level 1.
or DOWN arrow keys to
S
ENTER
ESC
MAE19060
arrow is pressed
3121200