Assembly - JLG T500J Service And Maintenance Manual

Assembly

HANDLE
NUT
ROLLER
1. Place one spacer over the bolt.
2. Lightly grease the split tube spacer.
3. Place the bolt and spacers through the roller. Insert the
bolt through the handle.
4. Install the locknut onto the bolt and tighten. Adjust the
nut so the bolt no longer turns freely. A minimum of two
full bolt threads must be visibly extended through the
nut.
3121200
HANDLE
SPLIT TUBE
SPACER
SPACER
BOLT
SECTION 3 - CHASSIS & TURNTABLE
CASTER WHEEL
1. Grease the outside of the wheel spacer using standard
automotive grease and insert it into the wheel.
2. Place the wheel and spacer into the yoke and align the
holes in the wheel with the holes in the yoke.
3. Insert the bolt through both sides of the yoke. Make sure
the threads of the bolt are to the outside of the yoke
when the yoke hangs down in the trailering position.
4. Install the locknut and tighten until the yoke is just tight
enough against the metal spacer to keep the spacer
from rotating. Do not overtighten, this can cause the
spacer to deform and bind the wheel. The wheel must
spin freely.
3-37