Installation - JLG T500J Service And Maintenance Manual

Installation

1. If removed, position the stabilizer in place on the frame
and install the pin, keeper, and bolt that connects the
stabilizer to the frame.
2. If removed, install the cylinder cover on the cylinder.
Using an adequate lifting device, position the cylinder in
place on the machine.
NOTE: The outrigger cylinder weighs approximately 72 lbs. (33
kg).
3. Install the bolt and keeper securing the pin at the pad
end of the stabilizer and install the pin.








3121200
SECTION 3 - CHASSIS & TURNTABLE
4. Lift the outrigger cylinder slightly up out of the frame to
gain better access to the hydraulic lines running to the
cylinder. Connect the lines to the cylinder as tagged dur-
ing disassembly.
5. Install the outrigger pin and outrigger cam pin and
secure in place with the retaining clips.
6. Using the analyzer and service mode, raise the outrig-
ger.
7. Function the outriggers several times to check for
proper operation and any leakage.
3-69