Replace Moving End Brackets - JLG T500J Service And Maintenance Manual

2. Parts used: Bracket Center Pin and Center Pin Snap Ring.
3. Take new bracket and install bracket center pin and
snap ring. Repeat on other bracket if replacing it.
NOTE: Ensure snap rings are seated in pin groove and closed
properly.
Correct
3121200

Replace Moving End Brackets

REPOSITION CABLES AND HOSES. KEEP COVERED DURING GRINDING TO PRE-
VENT DAMAGE.
Incorrect
SECTION 4 - BOOM & PLATFORM
1. Remove existing pins and center rivet. Remove rivet as
shown in link removal instructions on page 4-20. Repeat
on other bracket if replaced.
4-25