JLG T500J Service And Maintenance Manual page 129




NOTE: If the end cover has a valve or has five bolt holes, use the
line you previously scribed on the cover to radially align the
end cover into its original position.
3121200
SECTION 3 - CHASSIS & TURNTABLE
22. Assemble the 5 or 7 special bolts (1) and screw in finger
tight. Remove and replace the two alignment studs with
bolts after the other bolts are in place. Alternately and
progressively tighten the bolts to pull the end cover and
other components into place with a final torque of 
45-55 ft. lbs. (61-75 Nm) for the seven 3/8-24 threaded
bolts.
NOTE: The special bolts required for use with the relief or shuttle
valve end cover assembly (2) are longer than the bolts
required with standard and cover assembly. Refer to the
individual service parts lists or parts list charts for correct
service part number if replacement is required.
3-93