JLG T500J Service And Maintenance Manual page 87

3. Press a new dirt and water seal (20) into the housing (18)
outer bearing counterbore.
The Torqlink™ dirt and water seal (20) must be pressed in until
its' flange is flush against the housing.
3121200
SECTION 3 - CHASSIS & TURNTABLE
4. Place housing (18) assembly into a soft jawed vise with
the coupling shaft bore down, clamping against the
mounting flange.
5. On the Torqlinks™ assemble a new backup washer (17)
and new seal (16) with the seal lip facing toward the
inside of Torqlink™, into their respective counterbores in
housing (18) if they were not assembled in procedure 2.
ORIGINAL DESIGN LARGE FRAME, TF & TG TORQLINKS™ THAT DO NOT HAVE
BACKUP WASHER (25) WHEN DISASSEMBLED MUST BE ASSEMBLED WITH A
NEW BACKUP WASHER (17), NEW BACKUP WASHER (25), AND NEW SEAL (16).
3-51