Contents and general instructions
Designated use
Target group
Festo P.BE−CP−FB11−E−EN en 0802d
The CP field bus node type CP−FB11−E described in this man
ual has been designed exclusively for use as a slave on the
DeviceNet. CP modules from Festo can be connected to CP
field bus node CP−FB11−E. The CP node may only be used as
follows:
in accordance with designated use
in its original state
without any modifications by the user
in faultless technical condition.
If additional commercially−available components such as sen
sors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Please observe the standards specified in the relevant
chapters and comply with technical regulations, as well as
with national and local regulations.
This manual is intended exclusively for technicians trained in
control and automation technology, who have experience in
installing, commissioning, programming and diagnosing net
work modules on the DeviceNet.
V