Designated Use - Festo SEC-ST-48-6-P01 Fitting And Installation Instructions

Contents and general instructions

Designated use

VI
The SEC-ST-48-6-P01, referred to here as the SEC-ST, Smart
Electromotor Controller Stepper motor, has been designed for
use in control cabinets for controlling stepper motors in
2-string technology.
The SEC-ST must be operated in a safe working environment.
An EMERGENCY STOP circuit must be installed for the sys-
tem.
Operate the SEC-ST only under the permitted ambient condi-
tions.
The SEC-ST may only be operated in a stationary industrial or
commercial system. The electromagnetic resistance to inter-
ference of the power electronics is not designed for operation
in mobile systems, in households or in firms which are con-
nected directly to the low voltage network.
Install the SEC-ST screened and earthed in a control cabinet.
Otherwise, the electromagnetic compatibility (EMC) of the
power electronics cannot be guaranteed.
The SEC-ST may only be used as follows:
– in accordance with designated use
– in its original state
– without any modifications by the user
– in faultless technical condition.
If additional commercially-available components such as sen-
sors and actuators are connected, the specifiedlimits for pres-
sures, temperatures, electrical data, torques, etc. must not
be exceeded.
Please observe the standards specified in the relevant
chapters and comply with technical regulations, as well as
with national and local regulations.
Festo SEC-ST-48-6-P01-EN en 0111NH