Designated Use; Target Group; Service - Festo CECX-X-C1 Series Manual

The Festo_Motion.lib library
Figure: I/O configuration (example)
•
After completing the configuration, save the data in your project.
Refer to the Help for the CoDeSys programming system for more information on base and DP
parameters. The documentation for the relevant PROFIBUS station contains special information on
configuration and parameterisation.
1.3

Designated use

The function blocks (FBs) described are used to control and parameterise the associated device. You can
use them to conveniently integrate the many functions of the relevant device into your program. They are
integrated into the user program for each motor unit or motor controller (each axis) and called there
cyclically using a separate instance. Simultaneous use of other function blocks for controlling the same
device is not permitted.
Read the "Safety instructions" and instructions on the designated use of the relevant devices, components
and modules. If additional commercially available components such as sensors and actuators are
connected, the specified limits for pressures, temperatures, electrical data, torques, etc. must not be
exceeded.
1.4

Target group

This manual is intended exclusively for technicians trained in control and automation technology, who have
experience in installing, commissioning, programming and diagnosing positioning systems and the relevant
fieldbuses.
1.5

Service

Please contact your local Festo service centre or write to the following e-mail address if you have any
technical problems:
service_international@festo.com
–
4