Designated Use - Festo SPC200 Manual

Designated use

The SPC200 Smart Positioning Controller is designed
for fitting into a control cabinet. It serves as a position-
ing controller and closed loop controller for pneumatic
axes, as well as a positioning controller for stepping
motor axes. Basic modules and modules for the
SPC200 are described in this manual. Special exten-
sion modules are described in separate manuals.
The safety instructions must be observed at all times
and the various components and modules must be
used as intended. Please observe also the safety in-
structions listed in the operating instructions for the
pneumatic and electrical components used.
The SPC200 and the associated modules and cable
are only to be used as follows:
– as designated
– in original condition
– without unauthorised modifications
– in faultless technical condition.
The specified limit values for pressures, temperatures,
electrical data, torques, etc., must be observed when
additional commercially-available components such as
sensors and actuators are connected. Please comply
also with national and local safety laws and regulations.
VI
SPC200... 9904a