Designated Use; Service - Festo SPC-10 Manual

Designated use

The SPC-10 is designed for fitting into a machine or an
automated system.
In conjunction with a cylinder of type DGP(L)-..., the
potentiometer type MLO-POT-...-TFL and a proportional
directional control valve type MPYE-5-... , the SPC-10
can move at speed to one of two end positions set with
fixed stops. The end position cushioning is regulated
electronically. The cushioning path of the internal end
position cushioning of the cylinder (PPV) should not
project into the range of the working stroke.
The SPC-10 may only be used as follows:
– in accordance with designated use
– in its original state
– without any modifcations by the user
– in faultless technical condition.
When used together with commercially available com-
ponents, such as sensors and actuators, the specified
limits for pressures, temperatures, electrical data, tor-
ques etc. must be observed. National and local safety
regulations must also be observed.

Service

Please consult your local Festo repair service if you
have any technical problems.
V
SPC-10 9902a