Designated Use - Festo SPC200 Manual

Contents and general instructions

Designated use

Festo P.BE−SPC200−S7−PC−EN en 0609a
Function block SPC200−PC" serves for reading and writing
parameters of the SPC200 from a Simatic S7 controller with
PROFIBUS. For this purpose it uses the SPC200 parameter
channel (PC = parameter channel). The SPC200 must be
connected to the S7 by means of field bus module type
SPC200−COM−PDP.
Basic components and modules for the SPC200 are described
in the user manual type P.BE−SPC200−... . The safety
instructions specified in the manuals must always be
observed and the relevant components and modules must
only be used as intended. Please observe also the safety
instructions listed in the operating instructions for the
pneumatic components used. The SPC200 and the modules
and cables to be connected are only to be used as follows:
in accordance with designated use
only in industrial applications
without any modifications by the user. Only the conver
sions or modifications described in the documentation
supplied with the product are permitted.
in faultless technical condition.
When used together with commercially available compo
nents, such as sensors and actuators, the specified limits for
pressures, temperatures, electrical data, torques etc. must be
observed. National and local safety regulations must also be
observed.
Note also the Siemens specifications regarding the use of
their PLC Simatic S7.
V