Table of Contents
Advertisement
Positioning the control unit
Do not lean the control unit.
When changing, lay it on its back.
To position the control unit on the wall rail
1 Hold down the segments on the right and left, and tilt
the control unit fully downwards.
2 Hold down the release buttons on the left and right,
and remove the control unit from the Evita 4 mounting.
Uncoil the cable as far as necessary.
Clip the control unit to the wall rail and
3 lock in place = pull down the latch situated beneath
the bracket and turn it in the direction of the wall rail.
1 Hold down the segments on the right and left and at
the same time tilt the control unit to the desired
position.
To position the control unit on the device
Hold down the segments on the right and left and tilt
the control unit fully downwards.
Release the control unit = turn the latch away from the
wall rail and lift the control unit off the rail.
Coil the cable.
Hang the control unit in the Evita 4 mounting so that it
rests in position.
Hold down the segments on the right and left, and at
the same time tilt the control unit to the optimal
position.
1
2
3
Preparation
Positioning the control unit
1
2
47
Advertisement
Table of Contents
