Resetting Of Metered Values And Minimum/Maximum Values - Siemens siprotec 7SA6 User Manual

Control During Operation
7.1.3.4

Resetting of Metered Values and Minimum/Maximum Values

From the
Device Front
7-24
Metered values of measured values and minimum/maximum value memories can be
reset.
With the device ready for operation, first press the
key to select the menu item 0HDVXUHPHQW and switch to the list of
Use the
measured values using the
There, select the menu item 5HVHW with the
values using the key (see Figure 7-25).
5(6(7

!5HV0LQ0D[
!0HWHU UHV
3: 6HWWLQJV"

$UH \RX VXUH"
!<HV 1R (VFDSH
Figure 7-25 Setting of metered values and minimum/maximum values on front panel
With the keys and
To reset a memory, it must be marked by means of the keys
subsequently the key ENTER
A prompt for the entry of password No. 5 (for individual parameters) appears. After
entry of the password and confirmation with
the default answer "<HV" appears (Figure 7-25). Confirm with the key
corresponding measured values should really be reset. A message in the display will
then show the answer "&KDQJH RN". If you do not want to reset the measured values,
press the key, so that the answer "1R" is marked, and confirm with the
Before confirming with the
"12" using the and
resetting procedure.
key to return to the 0($685(0(17 submenu. Use the
Use the
the 0$,1 0(18.
key. The 0($685(0(17 selection appears.

! 

Enter password Nr. 5 (for individual
ENTER
parameters) and confirm with
Confirm "<(6" with the
complete the resetting of the selected
measured values, or switch to "12" with
the
the ENTER
paging up and down in the table is possible.
must be pressed.
ENTER
key, the responses can be toggled between "<(6" and
ENTER
keys. Alternatively, the
key. The 0$,1 0(18 appears.
MENU
key, and switch to the list of limit
ENTER
key and cancel the resetting with
key.
and
, the query "$UH \RX VXUH"", with
ENTER
ESC key can be pressed to cancel the
key to return to
MENU
C53000-G1176-C133-1
ENTER
key and
and
, if the
key.
ENTER
7SA6 Manual