Running The Test - AEMC 5050 User Manual

•
•
•
•
•
•
Once all fields in the Setup dialog box have been configured, it is recommended
that you perform the following steps.
1. Click on the Save button
2. Name and save the file.
3. Click on the Write button to configure the megohmmeter.
4. Click on the Close button to exit Setup and open the Control Panel.
7.3.2
After configuring the instrument (see § 7.3.1), the Control Panel will automatically
open. The Control Panel is used to initiate a timed test from the computer.
The Control Panel dialog box consists of five command buttons:
•
•
•
Megohmmeter Models 5050/5060
0.561.8187
Save to Disk: Saves the current configuration. This file will reside on the
computer's disk drive. Saving different configuration setups can be useful
for future functions and tests.
Load from Disk: Retrieves a saved file from the computer's disk drive to
be used in programming the megohmmeter.
Defaults: Resets all fields in the Setup dialog box back to the original
factory settings.
Set Clock: Programs the computer's time and date into the
configuration of the megohmmeter.
Clear Memory: Erases all contents in all memory locations in the
megohmmeter.
Download: Retrieves the stored data from all memory locations within
the megohmmeter for use on the computer's disk drive memory.
NOTE: While connected, both the DataView
open. They have similar main menu options, so you need to be aware of which
window you are working in.
You can tell which window you are working in by looking at the top left corner of
the active window. It will either display "DataView" or "Megohmmeter".
You can toggle between both windows via the Windows taskbar at the bottom of
your screen.

Running the Test

Start: This button begins a timed test.
Clear Display: Clears the statistical data, on the lower left side of the
screen, and the graph, on the right side of the screen.
Save to Disk: Saves the current data to a file in the computer.
www.
and Megohmmeter windows are
®
.com
information@itm.
49