Table of Contents
Advertisement
•
Read from Inst: Reads the current configuration of the megohmmeter
attached via the serial cable.
•
Save to Disk: Saves the current configuration. This file will reside on
the computer's disk drive. Saving different configuration setups can be
useful for future functions and tests.
Load from Disk: Retrieves a saved file from the computer's disk drive
•
to be used in programming the megohmmeter.
•
Defaults: Resets all fields in the Setup dialog box back to the original
factory settings.
•
Set Clock: Programs the computer's time and date into the configura-
tion of the megohmmeter.
Clear Memory: Erases all contents in all memory locations in the meg-
•
ohmmeter.
•
Download: Retrieves the stored data from all memory locations within
the megohmmeter for naming and storing on the computer's disk drive
memory.
Once all fields in the Setup dialog box have been configured, it is recommended
that you perform the following steps.
1. Click on the Save button
2. Name and save the file.
3. Click on the Write button to configure the megohmmeter with this new con-
figuration.
4. Click on the Close button to exit Setup and open the Control Panel.
NOTE: While connected, both the DataView
open. They have similar main menu options, so you need to be aware of which
window you are working in.
You can tell which window you are working in by looking at the top left corner
of the active window. It will either display "DataView" or "Megohmmeter".
You can select the Megohmmeter Control Panel via the Windows taskbar at the
bottom of your screen.
7.3.2
Running the Test
After configuring the instrument, the Control Panel will automatically open. The
Control Panel is used to initiate a timed test from the computer.
The Control Panel dialog box consists of five command buttons:
Shop for AEMC products online at:
• Start: This button begins a timed test.
Megohmmeter Models 1050 /1060
ShopAEMC
www.
and Megohmmeter windows are
®
.com
1.877.766.5412
49
Advertisement
Table of Contents
