Safety Information; Safety Warnings - W&H Lexa PLUS Instructions For Use Manual

Safety information

CONTENTS
This section deals with the following subjects:

Safety warnings

Responsibility
Safety warnings
THERMAL HAZARDS
The chamber automatically begins to heat to
n
high temperature as soon as the sterilizer is
switched on – risk of burns!
The trays and the sterilization load are hot at
n
the end of each cycle. Use tray or cassette
holders to empty the sterilization chamber.
Always wear appropriate PPE during use of the
n
sterilizer (e.g. gloves for cleaning, maintenance,
etc...).
12
ELECTRICAL RISKS
12
14
IMPROPER USE OF THE STERILIZER
Lexa PLUS | Instructions for Use | RIS-311 ENG Rev03 | 29/08/2022 | © W&H Sterilization Srl
Do not pour water or any other liquids over the
n
sterilizer (risk of electrical short circuits).
Switch off the sterilizer and unplug the mains
n
cable before inspecting, carrying out
maintenance or servicing the sterilizer.
Ensure that the power receptacle the sterilizer
n
is connected to is properly grounded.
All electric devices connected to the sterilizer
n
shall be of Insulation Class II (double insulated)
or higher.
Use only the power cord provided by the
n
manufacturer.
The sterilizer must not be used in presence of
n
explosive or flammable gases, vapors, liquids
or solids.
The sterilizer has not been designed for the
n
sterilization of foodstuff or waste.
Do not exceed the maximum load weight limits
n
as specified in this manual (see "Run a
sterilization cycle" on page 54).
Do not drink any water that has been inside the
n
sterilizer.