Source Initialization - Ametek L Series User Manual

L-Series and FCS-18- Graphical User Interface User Manual

6.1 Source Initialization

Source Initialization covers those source output parameters that can be
initialized to specific values at
power up. These values take
effect as soon as the AC source
is powered up and remain in
effect until changed from the
front panel or over the IEEE
interface. The initialization values
are retained in non-volatile
memory. The source initialization
screen can be used to inspect
the active initialization values
and if needed make
modifications.
Modifications made are
downloaded to the L-Series and
saved in non-volatile memory as
soon as the
affecting any changes, use the
Note that any changes made to the initial values do not affect the output
of the power source until after it has been powered down and back up.
38
button is clicked. To close this window without
California Instruments
instead.
Rev D – March 2011