Frequency Sweep Transient - Ametek L Series User Manual

L-Series and FCS-18- Graphical User Interface User Manual

7.2.7 Frequency sweep transient

Frequency sweep transients will cause the output frequency to change
gradually from the Goto F value to the Final F value over a period of time
specified by the Delay field. The delay value can range from 1 ms to 9999
seconds. At the end of the delay period, the output frequency will remain at
the value specified by the Final F field.
Note that if the Final F value is set to the same value as the Goto F value,
the F Sweep transient effectively becomes a F Step transient.
The illustration shown here reflects an example of a typical F Sweep
transient. The required row in the data entry screen for this transient would
be as shown below. In this case, register 0 was used to store the transient
information.
58
Frequency Sweep from 45 Hz to 180 Hz executed over a 150 ms period
California Instruments
120 ms
Rev D – March 2011