Source Menu - Ametek L Series User Manual

L-Series and FCS-18- Graphical User Interface User Manual

4.4.3 Source menu

The source menu provides front panel control of the L-Series. Available
sub-menus are :
Submenu
Initialization...
Steady State...
Transients...
24
Purpose
Opens the Source Initialization window. Initialization
parameters for frequency, voltage (all phases in a three
phase system), current limit and voltage range can be
set from the Initialization window. Changes made to this
window will be sent to the L-Series when the OK button
is clicked.
Opens the Steady State window. This is the virtual front
panel or soft front panel of the L-Series. This window is
non-modal and can be left open at all times while the
LSGUI program is running.
Opens the Transients windows. This modal window is
used to program the sixteen transient registers available
in the L-Series -P and -PT controllers. The same window
also provides a means to start transient execution from
any register.
California Instruments Rev D – March 2011